Pyle PLA1200 PLA2260 Manual 1 - Page 6

features and specifications MONO BLOCK AMPLIFIER PLA-1200 power supplies Stiffly regulated PWM power supplies. MOSFET switches maintain rated power over a wide range of battery voltages. sub sonic control When the sub sonic selector switch is in "ON" mode, this filter control permits continuously variable adjustment from 10 to 100Hz. bass boost level control This control permits adjustment of the bass level up to an increase of approximately up to 18dB. output power @ 14.4v DC, 50Hz RMS Power at @ 4 Ohms RMS Power at @ 2 Ohms RMS Power at @ 1.3 Ohms Maximum Power Output frequency response PLA-1200 200W MONO 350W MONO 600W MONO 1900W MONO 20 Hz-250 Hz (-3dB) crossover low pass filter Adjustable from 20Hz to 250Hz with a slope of 24dB per octave.This allows for the adjustment of the upper point of the frequency bandwidth and the respective subwoofer. input impedance 10K Ohms 4 input sensitivity 250mV~4V Adjustable high pass subsonic filter Adjustable from 15Hz to 40Hz with a slope of 24dB per octave.This allows for the attenuation of frequencies that are mostly inaudible and cause unnecessary strain on the amplifier. protection circuitry Protection against thermal, overload and short circuit conditions. remote dash-mount gain control This amplifier come complete with a compact remote GAIN CONTROLLER which can be conveniently mounted on or under the dashboard of your car. power supply voltage min speaker lmpedance T.H.D S/N ration fuse 14.4V DC Neg. Ground (10.5-16V) 2-4 Ohm 0.1% >90dB 20A x 2 dimensions (W x H x L) mm inches 270 x 36 x 305 10.63 x 1.42 x 12