Pyle PLA2480 PLA2480 Manual 1 - Page 5
PLA2380, PLA2480
View all Pyle PLA2480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
features and controls 2 ch amp PLA2380.PLA2480 PLA2380 PLA2480 power LED protection LED remote bass boost high pass frequency control low pass frequency control high level inputs 8 low level inputs input level control crossover mode selector bass boost level speaker connections power fuse power terminals features and specifications 2 ch amp PLA2380.PLA2480 crossover mode selector when used with normal, full range systems, set this switch to "FULL." If you wish to use the internal crossover to power a driver of specific frequency range, use the "LOWPASS" or "HIGHPASS" settings. input level control use this control to match the outputs of your head unit to the amplifier. Starting with your head unit set at about the 2 o'clock position, increase the amp level control until distortion begins to occur, and reduce slightly from this point. output power @ 14.4v DC, 1KHz RMS Power @ 4 Ohms RMS Power @ 2 Ohms Maximum Power Output PLA2380 2 channel amplifier 100 Watts x 2 150 Watts x 2 700 Watts x 2 frequency response 15 Hz-30 KHz PLA2480 2 channel amplifier 125 Watts x 2 180 Watts x 2 800 Watts x 2 low pass frequency control when the crossover selector switch is in "low pass" mode, this control sets input impedance the upper frequency limit for audio program sent to the speakers. low level inputs 10K Ohms high pass frequency control when the crossover selector switch is in "high pass" mode, this control high level inputs 100 Ohms sets the lower frequency limit for audio program sent to the speakers. Remote Bass Boost Plug in the Remote Bass Boost Control wire in here. input sensitivity 9 low level inputs 250mV bass boost level control this control permits adjustment of the bass level up to an increase of approximately 18 dB. high level inputs 2.5V low level inputs this amp features gold-plated RCA input jacks for high impedance input. Use these with car stereo output which uses RCA-type connector cables. high level inputs if your car stereo lacks RCA-type output jacks, you may connect speaker output leads to these input connectors. power LED this indicator is illuminated when power is applied. power supply voltage 14.4V DC Neg. Ground (10.5-16V) matching speaker impedance stereo mode 2-4 Ohms bridged mode 4-8 Ohms protection LED this indicator is illuminated when built-in protection circuitry is activated. maximum current draw 30A 30A power fuse the fuse protects the amplifier and your car's electrical system from short circuit conditions. power terminals use these connectors to deliver power, ground and remote turn-on control to the amplifier. dimensions (W x H x L) mm 276 x 69.5 x 343 inches 10.9 x 2.7 x 13.5 276 x 69.5 x 381 10.9 x 2.7 x 15 speaker connections these terminals are 14K gold plated to guarantee high conductivity and minimum signal loss.