Pyle PLCD36MRW Owners Manual - Page 15

TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is not on. If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to "ACC". The fuse is blown. Replace the fuse. Disc cannot be Presence of CD disc inside Remove the disc in the player, loaded or ejected. the player. then put in a new one. Inserting the disc upside down. Insert the compact disc with the label facing upward. Compact disc is extremely Clean the disc or try to play a dirty or defective disc. new one. Temperature inside the car Cool off or wait until the is too high. temperature returns to normal. Condensation. Leave the player off for an hour or so, then try again. No sound. Volume is too low. Adjust volume to a desired level. Wiring is not properly connected. Check wiring connection. Sound skips. The installation angle is more than 30 degrees. Adjust the installation angle less than 30 degrees. The disc is extremely dirty Clean the compact disc, then or defective disc. try to play a new one. The operation keys The built-in microcomputer Press the RESET button. do not work. is not operating properly Front panel is not properly fixed due to noise. into its place. The radio does not work. The radio station automatic selection does not work. The antenna cable is not connected. The signals are too weak. Insert the antenna cable firmly. Select a station manually. 16