Pyle PLMRC500X1 Instruction Manual - Page 6
Power Connection Leads
View all Pyle PLMRC500X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
POWER CONNECTION LEADS NOTES ON THE POWER SUPPLY • Connect the + 12V power input lead only after all other leads have been connected. • Be sure to connect the ground wire of the unit securely to a metal part of the car. • A lose connection may cause amalfunction of the ampli er. • REM: The unit is turned on by applying + 12 Volts to this terminal. This terminal does not draw heavy current like the tow Power Terminals so a thinner connecting wire is acceptable. Standard 20 GAUGE is ne and the standard color is blue. If the radio is equipped with a Power Antenna control wire, it can drive this terminal. If the Power Antenna wire is already in use, you can still splice into it. With this method, the unit will turn on automatically with the radio. • Use the power supply lead with a fuse attached whose value is the same as original fuse. • Place the fuse in the power supply lead as close as possible to the car battery. • During a full power operation, maximum current will run through the system. Therefore, make sure that the leads to be connected to the + 12V and GND terminals of the unit respectively must be larger than 10 - Gauge (AWG. 10). 6 www.PyleUSA.com