Pyle PLMRC500X1 Instruction Manual - Page 9

Troubleshooting

Get Pyle PLMRC500X1 PDF manuals and user guides View all Pyle PLMRC500X1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

TROUBLESHOOTING No Function The connection cable is not connected correctly (=terminaI + I2V/GND/REM). Ensure that all connections and mechanic contact and that the jacket has been removed. The fuse is defective-pay attention to the correct value of a new fuse! No Sound Speaker cable or speaker plug are not connected correctly. No Sound/Red LED Protection is lit The plus and minus wires of the speaker cable have contact, thus eliminate the short circuit. If you use a 1 Ohm speaker and the set is overloaded, then turn the gain control to "min" until the operation is free of trouble. Poor Sound Quality (Distortions) The speakers are overloaded, therefore turn down the volume level and check the volume control positions. No Stereo Sound and Weak Bass Speaker cables (+) and (-) are mixed up, unit wired out of phase. www.PyleUSA.com 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
www.PyleUSA.com
9
TROUBLESHOOTING
No Function
The connection cable is not connected correctly (=terminaI + I2V/GND/REM).
Ensure that all connections and mechanic contact and that the jacket has been
removed. The fuse is defective-pay attention to the correct value of a new fuse!
No Sound
Speaker cable or speaker plug are not connected correctly.
No Sound/Red LED Protection is lit
The plus and minus wires of the speaker cable have contact, thus eliminate the
short circuit. If you use a 1 Ohm speaker and the set is overloaded, then turn the
gain control to "min" until the operation is free of trouble.
Poor Sound Quality (Distortions)
The speakers are overloaded, therefore turn down the volume level and check
the volume control positions.
No Stereo Sound and Weak Bass
Speaker cables (+) and (-) are mixed up, unit wired out of phase.