Pyle PPCX2 PPCX2 Manual 1 - Page 5

LINK 3 to 1 3 XLR-M-JACK unbalanced link 1 GROUND 2 SIGNAL SLEEVE TIP 3 2 XLR-F-JACK unbalanced link SIGNAL LINK 3 to 1 1 GROUND TIP SLEEVE 4 PLEASE READ THIS MANUAL BEFORE OPERATING THIS UNIT Caution : To prevent malfunctioning and/or possible equipment damage: Before plugging the unit into the power source: (1) the voltage selector switch should be set For the correct voltage for your area (115V or 230V) and (2) all equipment connected to the Crossover outputs should be turned off or all the inputs turned down. 3 3 6 34 OFF +10 LOW GAIN CHANNEL 1 OFF ON 880 390 1.7K 4.1K 30HZ LOW CUT 250 6K XOVER FREQ OFF +10 HIGH GAIN PHASE SUB WOOFER 120 OFF ON 70 170 230 OFF +10 SUB GAIN 30HZ LOW CUT 50 250 XOVER FREQ OFF +10 LOW GAIN CHANNEL 2 OFF ON 880 390 1.7K 4.1K 30HZ LOW CUT 250 6K XOVER FREQ OFF +10 HIGH GAIN PHASE 4 2 5 8 7 5 23 2-WAY STEREO CROSSOVER PLUS SUBWOOFER ON OFF 1 AC INPUT 95-120V /210-240V 60-50Hz Rated Power Consumption 6W FUSE: 210-240V: T100mAL 250VAC 95-120V: 200mA 250VAC REPLACE FUSE WITH CORRECT TYPE ONLY HIGH OUT2 CHANNEL 2 SUB LOW OUT2 INPUT2 (UNBALANCED) INPUT2 (BALANCED) WOOFER HIGH OUT1 CHANNEL 1 LOW OUT1 INPUT1 (UNBALANCED) INPUT1 (BALANCED) 12 9 11 10 11 11 10 CONTROLS 1 ON/OFF SWITCH Caution: Always turn the Crossover ON before the amplifier, and turn it OFF after the amplifier or transients harmful to the speakers may result. 2 CROSSOVER FREQUENCY CONTROLS: These select the crossover frequencies of the LOW and HIGH ways. They are a low cut for the HIGH and a high cut for the LOW. You can select the frequencies between 250 Hz and 6 Hz. 3 L/H OUTPUT LEVEL CONTROLS: These are used to adjust the output level of each way: LOW and HIGH. 4 LOW CUT SWITCHES FOR LOW WAY: These insert low cut filters in the LOW way of each stereo channel with a 12dB/Octave, 30Hz HPF to minimize problems from subsonic frequencies in the signal, to suppress hum, and to prevent low frequency speaker resonance. 1