Pyle PRJS4384 PRJS43100 Manual 1 - Page 3
Adjusting Diagram
View all Pyle PRJS4384 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
-02- 2. ADJUST LIMIT SWITCH Adjust position for the two limit journey, refer to below picture: Adjulting knob for DOWN Adjusting knob for UP Adjusting Diagram 3.USEFUL INSTRUCTIONS a.The screen should be switched to a suitable power supply. it can be 220V / 50HZ,230V / 5OHZ.or t 1OV/ 60HZ.120V/ 60HZ.but the moto(s power must be same as the local voltage and frequency. b.The screen can be used with or without the remote controller. The remote control system can be radio type or infrared type, normally if a remote control system needed, a radio remote controller is supplied but an infrared type controller is also available for a special requirement these two different controlling functions can not combined in one control system. c.Normally a synchronized motor is installed inside the housing but a tubular motor is also available for a special requirement. d.lt the remote control system is not accompanied. the screen can Operated by the control box directly, just push the UP/DOWN / STOP button on the control box and operate the screen.Or the screen can be operated by the remote controller. e.The screen will automatically stops when the screen fabric goes up and back to the housing or when the top black border comes out totally. The screen can also stop at any position which you want.