Pyle PRJS4384 PRJS43100 Manual 1 - Page 7

-06- WALL-MOUNTED MANUAL SCREEN I.STRUCTURE HOUSING t BLACK BORDER RING SCREEN 2.INSTAWNG I PULLING RING \ PULLING ROD Moving Parts afthe drive must be installed higher than 2,5 mm above above the floor or other level that could provide access to it. Choose a suitable place for installing.it is best to install two screws onthe wall, the distance aftha screwsust be equal to that of the two rings and they should be at the same level, the rings must be strong enough to loading more than 25kg weights. 3 USEFUL INSRTUCTIONS Hold the pulling ring tightly and pull down the screen slowly. then stop when the black border comes Qut(or stop pulling where you want to stop), the screen can be auto-fIXed, if it can not be fixed, please operate it once again according to the same method. After using.release the screen and it will go up and back to the housing. 4.WARNINGS a The screen can not be folded.Do not use fingers or hard objects to touch the screen surface.Do not splash the milk, fruit juice or other chemical doses to the screen surface. Keep the screen far away from the high temperature objects orfire. b If the screen is dirty wash the screen gently by a broom or a cotton ball do not use the organic solvents to clean the screen surface. c When pulling the screen down, must be slowly and vertical. Do not pull it roughly, please stop pulling as soon as the black border is out or the screen is jammed or injured, then send the screen to the maintenance center. d After using, put the screen back to the housing in order to avoid being polluted, If not using it for a long time,please take the screen from the wall and pack it in a carton.