Pyle PT592A User Manual - Page 7

Trouble Shooting Use this chart to help you solve operational problems. If there are any problems that can not be solved, please con tact Se rvice Center. Problem Possible Reasons Solutions No Power The Plug is not inserted properly The Socket has no power Check Power Supply and Plug Check socket and power supply Display can't be turned on The fuse is burned You have not pressed the "Power" button Replaced the fuse Press the "Power" button No Sound at All Neither of the main channels have sound Center channel has no sound Side Surround channels have no sound The sound of surround channel is low The sound of center channel is low Sound from the speakers is out of order No sound when you choose HDMI input Incorrect selection of input signal The wire and lead are not connected correctly The mute is turned on The source of the audio is not turned on The speaker is not connected properly The plugs of the audio source are not connected correctly or connection wires between devices have a short The speaker is not corrected properly Mode is not set properly The speaker line is not connected properly Mode is not set properly The sensitivity of the speakers is too low The volume is too low The input signal is STEREO The sensitivity of the speaker is too low The volume is too low Speakers are located improperly The speaker cables are not connected properly or the disc is defective Source of audio is not powered on The HDMI is not connected properly Source of audio is not set to HDMI mode Read the manual again carefully Check wire and lead Press the mute button turn off the mute Turn on the source of the audio Read the manual carefully Check the connection of the audio source plugs and wires Read the manual Mode should be set so that the surround channels have output, for example: 5.1 channel Read page 3 of the manual Mode should be set so that the surround channels have output, for example: 5.1 channel Adjust volume Change to 5.1 channel Adjust volume Read the manual Turn on the power of audio source Read the manual Set the audio source to HDMI mode .5.