Pyle PT592A User Manual - Page 8

Audio

Page 8 highlights

Audio The FM/AM reception is poor Need outdoor antenna Radio stations cannot be tuned in Check that the antennas are connected securely Connect FM/AM antenna to outdoor antenna, CAUTION: avoid lightning Adjust the antennas and connect an external antenna, if necessary The signal strength of stations are to weak (try manual tuning) No stations have been preset or the preset stations have been cleared (try tuning manually) Adjust manually Make sure you set the tuning interval correctly The remote control does not function Error Message Protection mode shuts unit off Obstacles exist between the remote and the receiver Remove any obstacles in the path between the remote and the reciever The remote batteries are weak Replace the batteries in the remote control for new ones Incorrect input selection on the remote control Make sure you select the correct input on the remote control If message appears, there may be a malfunction Check the condition of the system that correlates with the message Should problem persist Contact [email protected] Irregular current is being output to the speakers. The receiver will automatically turn off after a few seconds Power unit off, check all speaker cables and connections, power unit on again. (May be a problem with internal circuitry of your speakers)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

Audio
The FM/AM reception is poor
Need outdoor antenna
Connect FM/AM antenna to outdoor
antenna, CAUTION: avoid lightning
Radio stations cannot be tuned in
Check that the antennas are
connected securely
Adjust the antennas and connect an
external antenna, if necessary
The signal strength of stations
are to weak (try manual tuning)
Adjust manually
No stations have been preset or the
preset stations have been cleared
(try tuning manually)
Make sure you set the tuning
interval correctly
The remote control does
not function
Obstacles exist between the remote
and the receiver
Remove any obstacles in the path
between the remote and the reciever
The remote batteries are weak
Replace the batteries in the remote
control for new ones
Incorrect input selection on the
remote control
Make sure you select the correct input
on the remote control
Error Message
If message appears, there may
be a malfunction
Check the condition of the system that
correlates with the message
Should problem persist
Protection mode shuts unit off
Irregular current is being output to the
speakers. The receiver will automatically
turn off after a few seconds
Power unit off, check all speaker cables
and connections, power unit on again.
(May be a problem with internal
circuitry of your speakers)