Pyle PTA22BT Instruction Manual - Page 3
Wireless Bt Streaming Operation Instruction, Caring For Your Pyle Amplifier
View all Pyle PTA22BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
13. SWITCHABLE MIC PAGER AND MIXING MODES: Set to PAGER, allows a voice to be heard clearly through the microphone by attenuating automatically all the audio input source.This is good to use when paging the person in o ce, store, or restaurant. Set to MIXING, both of the voices from the microphone and music will exist at the same time. It is similar like playing at KARAOKE events. BACK PANEL 14. Wireless BT Antenna: Wireless BT Streaming receiver 15. Fuse: The ampli er uses fuse for protection against surges and short circuit. If the ampli er suddenly turns o and will not turn on, check the fuse. If necessary, replace it with a 1-amp, 250-volt, fast-acting, 5x20mm fuse (not supplied). 16. 1/4" MIC INPUT JACK: Lets you connect a microphone with a 1/4" plug. 17. AUX1/AUX2/CD RCA INPUT: Lets you connect to most high-level audio sources such as CD player, tape deck, tuner, camcorder or VCR. 18. REC RCA OUTPUT: Lets you connect the ampli er to a tape deck for recording. 19. Push Type Speaker L/R Terminals: Let you easily connect the speaker wires directly to the ampli er 20. 110V/220V Switch: According to power voltage, push this button to the correct station of the 110V or 220V. 21. AC IN Power Cord: Connect to AC 110V/60Hz or 220V/50Hz 22. FM ANTENNA CONNECTOR: Connect for AM and FM antennas 4 www.PyleUSA.com WIRELESS BT STREAMING OPERATION INSTRUCTION External devices which have a built-in BT feature can be connected to this ampli er wirelessly to play through the ampli er's speakers. If your amp is connected to speakers, you will hear audible tones which will help for connecting. 1. At rst be sure that the ampli er is powered ON, and turn the volume to low. Pull out the BT Antenna at the back panel for better receiving signal. Press MODE button on the front panel then the BT Indicator light will be lit. (The unit is automatically ready to pair with your device) 2. Turn ON the Wireless BT function of your external device. 3. Search for available devices within range of your external Wireless BT device. 4. Wait for a while then nd the "PYLEUSA" on the paired devices list on your external device and select "PYLEUSA", or nd the "BT" on the paired devices list on your external device and select "BT". 5. Your ampli er will beep and the lights will ash once when pairing is successful. 6. You can now play music and other audio on your external device through your ampli er. 7. The ampli er will beep and the lights will ash once again when the external device is turned o or unpaired. CARING FOR YOUR PYLE AMPLIFIER Your Pyle Ampli er is an example of superior design and craftsmanship. The following suggestions will help you care for your ampli er so you can enjoy years of use: • Keep the amplifier dry. If it gets wet, wipe immediately. • Use the amplifier only in well-ventilated installations. • Handle the amplifier away from dust and dirt. • Wipe occasionally with a damp cloth to keep it looking new. • Do not use harsh chemical, solvents or detergents! www.PyleUSA.com 5