Pyle PUCRC25 Instruction Manual - Page 13
Problem, Possible Cause, Solution
View all Pyle PUCRC25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Red LED stays after power on Vacuum is on but cannot collect dirt and hair 1. Battery low condition 2. Main body is picked up 1. The dust bin is full 2. The lter is not installed correctly 1. Recharge the battery 2. Re-place the robot on the oor 1. Clean the dust bin 2. Reinstall the lter correctly The product is moving backwards after being started Blue LED indicators will ash after 4 hrs charging 1. The product is on dark colored ooring 2. Anti-drop sensor light was covered Power supply might been cut o during charging 1. Put the robot on light colored ooring. 2. Clean anti-drop sensor light. Charge the battery in full 4 hours The side brushes is crooked & not good to sweep Being used for a long time If it becomes crooked, please scald it in hot water to recover it to its original shape The product wont start 1. Batteries were not installed properly 2. Battery low 3. The robot is under protection status 1. Install the battery correctly 2.To fully charge the battery (turn o the cleaner) 3. Re-set the robot The product moves around in circles only, wont go straight One of the wires of the wheels might be loosened 1. Open the wheel cover and connect the loosen wire properly 2. Send the robot to seller for repair 8 Battery reset Unplug the battery from the device then press and hold the power button for 10 seconds. Then reconnect the battery. www.PyleUSA.com 13