RCA ANT1250 User Guide - Page 5

ANT1250_IB 7/19/01 9:12 AM Page 5 Hooking Up a CABLE, SATELLITE or DBS SATELLITE SYSTEM to Your Antenna Your cable, satellite, or DBS Satellite System can be directly connected to the Antenna allowing access to off-air local programming. By a simple flick of a switch on the back of the antenna, you can switch from your local off-air programming to cable, satellite or DBS Satellite System programming. 1. Connect the power supply to your antenna by plugging the cord into the jack marked 12VDC, 200mA on the back of the antenna. 2. When the switch is in the CABLE IN position, the signal from your cable, satellite, or DBS Satellite System will pass through the antenna to your TV or VCR without interference. 3. To hook-up your cable, satellite, or DBS Satellite System to the antenna, connect the "OUT TO TV" cable from the antenna to the TV or VCR connector marked "IN FROM CABLE". 4. When the switch is in the AMP position, you will receive local programming from amplified off-air signals via the antenna. 5. When the switch is in the BY PASS OFF-AIR SIGNAL position, the off-air signal will travel to the TV without amplification. Use this position when the antenna is used near transmitters and amplification is not necessary. A B C D A Power Insert B 3 Position switch C Cable connector D Integrated Coaxial Cable 5