RCA OARP05S Owners Manual - Page 3

NOTE:

If the DVD/VCR key did not blink twice after

entering the codes last digit, repeat steps 2 and 3 and

try entering the same code again. If you’ve located

a setup code that works for your combo device (for

example, a TV/VCR Combo) and a separate TV code

is also listed, you’ll need to program this code into

the remote control to access volume control (see the

“Programming Device Control” section).

The device should turn off. If it does not respond,

repeat steps 2 and 3, trying each code listed for your

brand until you find one that works. If it still does not

5.

For future reference, write down each working device

code in the boxes below:

Searching For Your Code

If your home entertainment device does not respond to the

OARP05S Cable Replacement Remote after trying all of the

codes listed for your brand, or if your brand is not listed at

all, try searching for your code.

5.

Press and release the CH+ key continuously, then stop

NOTE:

In the search mode, the remote control will send

IR codes from its library to the selected device, starting

with the most popular code first.

indicate that the code is saved.

NOTE:

If the TV does not turn on during step 6, then

slowly press and release CH- to go back through the

codes, then press SETUP when the TV turns on.

they don’t, repeat steps 1-4 above. In step 5, don’t stop

CH+ until it turns off again.

NOTE:

By default, the CH+/- keys change channels on

the CBL/SAT device regardless of what mode you’re in.

So, you should only use these keys to test for CBL/SAT

device codes at this point.

8.

To search for the codes of your other devices, repeat

steps 1 through 6, but substitute the appropriate key

device you’re searching for.

Checking the Codes

If you have set up your remote control by searching for

your device code, you may need to find out which four-

digit code is operating your equipment.

3.

To view the code for the first digit, press 1 once. Count

NOTE:

If a code digit is 0, the selected mode key will not

blink.

4.

Repeat step 3 three more times for the remaining

digits. Use 2 for the second digit, 3 for the third digit,

and 4 for the fourth digit. Finish writing down the code

5.

To check for other device codes, repeat steps 1 through

Using Learning

The OARP05S Cable Replacement Remote includes a

Learning Precautions

for learning to work properly.

unique function for each mode.

on the code being learned.

multi-frequency types, some high frequency ones, and

other unusual formats.

light such as natural sunlight or energy-efficient

fluorescent lights.

NOTE:

Please have your original remote controls handy

before programming learning.

Programming a Learned Key

NOTE:

If more than 15 seconds pass between key

presses, the remote exits programming.

NOTE:

If the LED displays one long flash instead,

either your batteries are low, or the OARP05S Cable

Replacement Remote has a memory fault.

3.

Press the desired key on the OARP05S once to store the

feature to be learned.

the OARP05S Cable Replacement Remote to learn.

2"

5.

On the original remote, press and hold the key to be

turn off. Continue holding the key on the original

NOTE:

If the LED displays one long blink, a learning

error has occurred. Try repeating this step again until

a successful capture occurs. If the function is still not

captured, press and hold SETUP to exit programming

and review the “Learning Precautions” earlier in this

section. If needed, also see “Troubleshooting” later in

this manual. After review, start programming again at

step 1.

blinks twice to exit programming.

RCA OARP05S Owners Manual - Page 3

Using Learning - codes

Page 3 highlights