RCA RCRPS04GR Owner/User Manual - Page 17

ENGLISH To enable Master Power again: 1. Press and hold the P key for 3 seconds. The POWER key comes on. 2. Press VOL+ to enable Master Power again. 3. Press the P key to confirm. The Master Power function is enabled again. Reassigning the AUDIO•AUX or DVD•VCR Key The AUDIO•AUX key defaults to control an audio receiver, and the DVD•VCR key defaults to control a DVD player. If you want the AUDIO•AUX or DVD•VCR key to control a different device (an additional TV, DVD, satellite or cable box, for example), you must reassign it. 1. Press and hold the AUDIO•AUX or DVD•VCR key. The POWER key turns on. 2. While holding down the AUDIO•AUX or DVD•VCR key, press and release the number key on the keypad for the device you wish to control (see the chart below). The POWER key turns off. AUDIO•AUX OR DVD•VCR KEY CONTROLS: Additional TV press 1 VCR or DVR press 2 Additional DVD press 3 Additional audio device press 4 Additional satellite receiver, cable box, press 5 or DTV converter 3. Release the AUDIO•AUX or DVD•VCR key. The POWER key blinks four times and then turns off. The AUDIO•AUX or DVD•VCR key is now set to control the device type you selected. 4. Follow the directions in the auto, brand, direct entry, or manual code search to program the AUDIO•AUX or DVD•VCR key. Volume Punch-Through Volume Punch-Through allows the VOL and MUTE keys, when pressed in SAT•CBL•STREAM or DVD•VCR modes, to "punch through" to either TV or AUDIO•AUX, whichever was accessed last. Volume Punch-Through occurs automatically and allows you to control the volume without exiting the current mode. (If the DVD•VCR key has been programmed with a TV or AUDIO code, volume can punch through to this device as well.) Note: Volume Punch-Through does not occur in cases where the component code has its own volume/mute controls, such as some satellite receivers. 17