Radio Shack 43-473 Owners Manual - Page 8

43-473.fm Page 8 Friday, August 13, 1999 9:21 AM OPERATION SETTING THE BEEP You can set the telephone cassette recorder to beep every 15 seconds while recording. 2. Press STOP/EJECT to open the cassette compartment door. Put the cassette in the compartment with the cassette's open edge facing you and the full reel on the left. Note: You might be legally required to set BEEP TONE to ON when recording, so all parties know the conversation is being recorded. Check the laws in your area. 1. Remove the battery compartment cover and remove the batteries, if installed. 2. Set BEEP TONE to ON. The telephone cassette recorder beeps every 15 seconds while recording. ALWAYS DISCONNECT ALL TELEPHONE LINES FROM THE WALL OUTLETS BEFORE SERVICING OR DISASSEMBLING THIS EQUIPMENT, OR REPLACING BATTERIES. + --- DC 6V (UM/SUM-3) X4 + --- + --- BEEP TONE ON OFF + --- 3. Replace the batteries and the cover. LEVVUEL MIC 3. Close the door. Notes: • You can buy cassettes of varying lengths at your local RadioShack store. • Replace the tape at least once a year, or more often if it is used heavily. RECORDING A PHONE CONVERSATION LOADING A CASSETTE TAPE Follow these steps to install a cassette tape (not supplied) in the recorder. 1. Turn the cassette's hub with a pencil to take up any tape slack. You can record both sides of a conversation on any phone connected to the same phone line as the recorder. 1. Set REC MODE, the sensitivity level, SPEED, and MONITOR to the desired settings. (See "Setting the Record Mode" on Page 9, "Setting the Sensitivity Level" on Page 9, "Setting the Recording Speed" on Page 10, and "Listening While You Record" on Page 10.) 8