Rane CP52S CP52S Installation Manual - Page 4

CP52S COMMERCIAL PROCESSOR INPUT TRIM DETECT THRESHOLD +30 +60 MIC LINE OL ACTIVE PAGING PROGRAM INPUT LEVELS ZONE LEVEL 4 6 LIMIT THRESHOLD +8 2 8 -3 +16 LINE 1 4 6 2 0 10 -20 +20 0 10 LIMIT LINE 2 4 6 0 10 LINE 3 4 6 0 10 PRIORITY 4 6 8 DUCKER DEPTH PROGRAM SELECT L2 L3 L1 P REMOTE LEVEL 4 6 LIMIT THRESHOLD +8 2 8 -3 +16 OFF ON 0 10 0 10 SIG OL -20 +20 LIMIT EQ + 12 • 6 • 0 • 6 • 12 40 100 250 630 1.6k 4k 10k POWER CP52S COMMERCIAL PROCESSOR Quick Start If you were the type that cheated on school book reports by just skimming through the reading assignments, then this section is for you! It gives you not quite enough information to really know what you're doing. But, if you follow the recommended set up procedure, you should get at least a "B." Keep the amplifiers and the CP52S turned off until all connections are made. PAGE INPUT Connect the PAGING INPUT to the Euroblock on the rear panel. On the front, select the appropriate MIC or LINE switch position. Then set the gain with the INPUT TRIM control, then set the PAGING DETECT THRESHOLD and finally the PAGING LEVEL. MIC PHANTOM POWER, HIGH/LOW CUT FILTER and PAGE LEVEL TRACKS ZONE LEVEL switches are located on the rear panel. PROGRAM INPUTS Connect line level program sources to the RCA PROGRAM INPUT jacks (LINE L1, L2, L3 & PRIORITY). If you have a priority program, like a jukebox, connect it to the PRIORITY Input. The rear panel PRIORITY switch turns priority override ON or OFF. The Priority program is automatically selected when signal is detected at its Input. Set the rear panel PROGRAM DETECT THRESHOLD and RELEASE TIME as desired. EXPAND OUTPUT Wire the EXPAND OUTPUT Euroblock as required to a mono feed delivering PAGE-only, PROGRAM-only or ZONE (both) signal depending on the switch setting. This Output uses a crosscoupled line driver and may be used balanced or unbalanced. Adjust the EXPAND OUTPUT LEVEL trim as desired. ZONE OUTPUT The ZONE OUTPUT uses a cross-coupled line driver and may be used balanced or unbalanced. Set the front panel LIMIT THRESHOLD as required. Depress the rear panel MONO switch for a mono Zone. ZR1 REMOTE You may use one ZR1 Remote (sold separately) with the CP52S. Wire it to the ZONE REMOTE Euroblock as indicated. If a ZR1 remote is not used, any simple switch closure to ground will work for the D0 and D1 pins. These pins are TTL compatible (0 to 5 VDC). The logic is inverse Gray Code. Any ground referenced 5 volt DC control may be used as the input to Vc. Do not ground the Vr pin. READ ME The CP52S is very versatile. While this makes a large number of system applications possible, it also results in complexity. For this reason, it is important to use an organized approach for setup and calibration. A highly recommended setup is at "Recommended Calibration Procedure" on page 10. Please follow it to encounter fewer problems and reduce the need to increase our collective phone bills. WEAR PARTS: This product contains no wear parts. 4