Rane CP64S CP64S Data Sheet - Page 2

CP64S COMMERCIAL PROCESSOR Features and Specifications Parameter MIC/LINE PAGING INPUTS ..........Input Type ..........RFI Filter ..........Gain range ..........Frequency Response ..........Input Referred Noise ..........CMR ..........THD+N ..........Phantom Power ..........Mic Input impedance ..........Line Pad ..........Line Input impedance ..........Signal Detector Range ..........Signal Detector Attack ..........Signal Detector Release ..........Overload Indicator ..........Front Panel Zone Assign ..........Remote Zone Assign ..........Pre/Post Paging assign ..........Page Priority Assign ..........Paging Zone Level Adjust ..........Page Remote Selector PROGRAM INPUTS ..........Input Type ..........Input Level adjust ..........Frequency Response ..........Input impedance .....Priority Program Input Input Detector Range Release Time Range Attack Time Assign EXPAND OUTPUTS ..........Number of Expand Outputs ..........Expand Selector ..........Output Type ..........Gain: Zone Page/Program ..........Frequency Response Specification Limit Units Conditions/Comments Two mono All controls duplicated for both inputs Euroblock Balanced; Instrumentation amplifier Yes +30 to +60 2 dB Continuously adjustable 30 Hz to 40 kHz +0/-3 dB Maximum gain -125 1 dBu Gain: 60 dB, Rs: 150 Ω, BW: 20 kHz 40 min dB 20 to 20 kHz .05 .01 % Gain: 30 dB, +4 dBu out, 1 kHz, BW: 80 kHz +15 4% VDC Internal switch 500 1% Ω Each leg to ground 30 1 dB 14.5k 1% Ω Each leg to ground. Defeats phantom power off to +4 typ dBu Continuously adjustable .5 typ msec Fixed 3 typ sec Fixed +16 1 dBu 4 dB before clipping. Remote, Z1, Z2, Both Z1 = Zone 1; Z2 = Zone 2 Off, Z1, Z2, Both Internal pull-up; Active low; Switch closure to ground or 5 volt TTL logic. Summed with program Pre VCA or Post VCA via Internal switch P1 (Page 1) NO (none) P2 (Page 2) 1 dBu Priority pager overrides non-priority pager only in assigned zones; Selecting NONE allows the two pagers to mix. off to 0 dB Independent for each Zone 11 = Off 10 = Z1 (Zone 1) 01 = Z2 (Zone 2) 00 = Both 1 dBu Internal pull-up. Active low; Switch closure to Ground or 5 volt TTL logic. Four stereo All controls duplicated for all four inputs RCA Unbalanced off to 0 dB 10 Hz to 50 kHz +0/-3 dB 10 k 20% Ω off to -35 5 to 20 50 OFF, Z1, Z2 or Both Two Zone Program only Page only Balanced 12 6 10 Hz to 50 kHz typ dBu Internal trim, factory set to -50 dBu typ sec Internal trim, factory set to 12 seconds typ msec For a 20 dB step; Fixed. 1 dB 1 dB +0/-3 dB All controls duplicated for both zones Z1 & Z2, both mono Note: If a Page signal is summed Post-VCA, it is not present on the Expand Zone output. It is available for the Expand Page output. Cross-coupled; Euroblock connector Data Sheet-2 continued...