RedMax GZ4000 Owners Manual - Page 24
Cutter length, Filing angle, Side plate angle, Top plate cutting angle, GUIDE BAR, Ruler, No gap,
View all RedMax GZ4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
10. Maintenance of Saw Chain and Guide Bar F38 Make sure every cutter has the same length and edge angles as illustrated. (F38) (4) Cutter length (5) Filing angle (6) Side plate angle (7) Top plate cutting angle ■ GUIDE BAR • Reverse the bar occasionally to prevent partial wear. • The bar rail should always be a square. Check for wear of the bar rail. Apply a ruler to the bar and the outside of a cutter. If a gap is observed F39 between them, the rail is normal. Otherwise, the bar rail is worn. Such a bar needs to be corrected or replaced. (F39) (1) Ruler (2) Gap (3) No gap (4) Chain tilts 24
24
10. Maintenance of Saw Chain and Guide Bar
Make sure every cutter has the same length and
edge angles as illustrated. (F38)
(4) Cutter length
(5) Filing angle
(6) Side plate angle
(7) Top plate cutting angle
■
GUIDE BAR
•
Reverse the bar occasionally to prevent partial
wear.
•
The bar rail should always be a square. Check
for wear of the bar rail. Apply a ruler to the bar
and the outside of a cutter. If a gap is observed
between them, the rail is normal. Otherwise, the
bar rail is worn. Such a bar needs to be
corrected or replaced. (F39)
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
F38
F39