Reebok Rbx 500 English Manual - Page 6

HOW TO SET UP THE TREADMILL Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until setup is completed. No tools are required. 1. With the help of a second person, carefully raise the Uprights (39) until the treadmill is in the position shown. 1 39 2. Make sure that the Lock Knob Sleeve (18) is pressed into the left Upright (39). 2 Make sure that the two Lock Pin Collars (20) and the Spring (19) are on the Lock Pin (49). Insert the Lock Pin into the Lock Knob Sleeve (18) and the left Upright (39). Tighten the Lock Knob (17) onto the Lock Pin. 17 39 18 19 49 20 3. Make sure that all parts are tightened before you use the treadmill. Place a mat under the treadmill to protect the floor or carpet. If you purchase the optional heart rate monitor (see page 20), follow the steps below to install the receiver included with the heart rate monitor. 1. Remove the eight indicated Screws (41) from the back of the Console Base (46). 2. Lift up the Console (103) as shown; be careful not to pull any wires. Peel the paper off the pad on the back of the Receiver (A). Turn the Receiver so the cylinder is on the side shown, and press the Receiver into the bottom of the Console Base (49) in the indicated location. Next, connect the Jumper Wire (B) to the wire on the Receiver. Connect the other end of the Jumper Wire to the PULSE 1 jack on the back of the Console. Position the Reading Rack (48) in front of the Console (103). Carefully set the Console back onto the Console Base (46). Make sure that no wires are pinched. Reattach the Console with the eight Screws (see step 1). 1 2 48 A 46 41 103 PULSE 1 Jack B 49 2 1/2Ó 6