Reebok Rt445 Bike User Manual - Page 7

7. Attach the Seat (12) to the Seat Post (11) with four Seat Screws (29) and four M8 Flat Washers (18). Note: The Seat Screws and Flat Washers may be pre-attached to the Seat. Using an adjustable wrench, remove the Seat Knob Assembly (31) from the Frame (1). Insert the Seat Post (11) into the Frame (1). Slide the Round Collar (13) down the Seat Post and press it into the Frame. Attach the Round Collar to the Frame with an M6 x 8mm Screw (26). Reattach the Seat Knob Assembly (31) to the Frame (1). 8. Identify the Left Pedal (40); the threaded shaft on each Pedal is marked with an "L" for "left" or an "R" for "right." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Left Crank Arm (34). Tighten the Right Pedal (not shown) clockwise into the Right Crank Arm (not shown). Important: Tighten both Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened. Identify the Left Pedal Strap (41), which is marked with an "L." Attach the Left Pedal Strap to the Left Pedal (40), and adjust the Left Pedal Strap to the desired position. Attach and adjust the Right Pedal Strap (not shown) in the same way. 9. Attach the Water Bottle Holder (63) to the Frame (1) with two M4 x 16mm Screws (21). Note: The water bottle holder is designed to be used with your own water bottle. 7 12 11 13 1 18 29 26 31 8 34 41 40 9 21 63 1 10. Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some hardware may be left over after assembly is completed. Place a mat under the exercise cycle to protect the floor or carpet. 7