Ricoh AP410 Support Guide - Page 7

G112/G113/G116 Product Support Guide Utility Software: Software Font Manager (Win95/98/ME, NT4, 2000, XP, Server 2003) Smart Net Monitor for Admin (Win95/98/ME, NT4, 2000, XP, Server 2003) Smart Net Monitor for Client (Win95/98/ME, NT4, 2000, XP, Server 2003) Printer Utility for Mac PS Descriptions IEEE1394 Utility (Win2000, XP) Description • A font management utility with screen fonts for the printer. • A printer management utility for network administrators. • Setup utilities are also available. • A printer management utility for client users. • A utility for peer-to-peer printing over a NetBEUI or a TCP/IP network. • A peer-to-peer print utility over a TCP/IP network. This provides parallel printing and recovery printing features. • This software provides several convenient functions for printing from Macintosh clients. • PDD for Mac • This utility solves problems with Windows 2000. G112/G113/G116 Total Counter Access: • Menu -> List/Test Print -> Config. Page. Pages Printed. Total counter limit 6 digits. • Total counter can be displayed and printed only if the meter change mode is set to yes in SP 5- 930. Menu --> (counter displayed) Enter --> Arrow Down (print is displayed) --> Enter. • Total counter can also be displayed in SP 7-993; this counter includes all prints including service reports. • In the G116 only, the SP 5-104 specifies whether the counter is doubled for 11 x 17. There is no extra counter for these reading, it is added to the total. Installation Requirements: Temperature Range: 10° C to 32° C (50° F to 90° F) Humidity Range: 15% to 89% RH Ambient Illumination: Less than 2,000 lux (do not expose to direct sunlight) Ventilation: 3 times/hr/person Ambient Dust Less than 0.10 mg/m³ (2.7 x 10/6 oz/yd³) Avoid areas exposed to sudden temperature changes: • Areas directly exposed to cool air from an air conditioner • Areas directly exposed to heat from a heater Do not place machine where it will be exposed to corrosive gas or vapor. Some Blue Print machines use an ammonia based development process, which may produce a corrosive vapor. Do not install the machine at any location over 2,500m (8,125 ft.) above sea level. Place the machine on a strong and level base. Inclination on any side should be no more than 5mm (0.2") Do not place the machine where it may be subject to strong vibrations. Machine level • Front to back: within 5mm (0.2") of level • Right to left: within 5mm (0.2") of level V2.0 9/1/2006 Page 7 of 19