Ricoh Aficio MP 6000 S/P Network Guide - Page 69
appletalk, authfree, autonet, Parallel/USB settings
View all Ricoh Aficio MP 6000 S/P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Remote Maintenance by telnet appletalk ❖ IPv6 address mask settings msh> authfree "ID" mask6_ Use the "appletalk" command to addr1 masklen view and configure Appletalk parameters. ❖ Parallel/USB settings msh> authfree [parallel| ❖ View settings usb] [on|off] msh> appletalk To enable authfree, set to "on". To 2 disable authfree, set to "off". • [2] means "active" and [0] Always specify the interface. means "inactive". • The default is [2]. ❖ Authentication exclusion control initialization ❖ Changing PAP timeout configuration msh> authfree flush msh> appletalk ptimeout value > 0 • Timeout value becomes effective. msh> appletalk ptimeout Note ❒ For IPv4 and IPv6, up to five access ranges can be registered and selected. value = 0 • Timeout value becomes ineffec- autonet tive. Use the "autonet" command to con- figure AutoNet parameters. authfree ❖ View settings Use the "msh> set bonjour" command to display and configure au- The following command displays the current AutoNet settings: thentication exclusion control msh> autonet settings. ❖ View Settings msh> authfree ❖ Configuration You can configure AutoNet settings. If print job authentication exclu- msh> autonet {on|off} sion is not set, authentication exclusion control cannot be displayed. • {on} means "active" and {off} means "inactive". ❖ IPv4 address settings ❖ Current interface priority configuration display msh> authfree "ID" range_ addr1 range_addr2 msh> autonet priority ❖ IPv6 address settings msh> authfree "ID" range6_ addr1 range6_addr2 61