Ricoh Aficio MP 6000 S/P Network Guide - Page 77
info, ipp, msh> ipp auth {basic|di
View all Ricoh Aficio MP 6000 S/P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Remote Maintenance by telnet ❖ Changing the Interface msh> ifconfig "interface" up ipp • You can specify either the Ethernet interface or IEEE 802.11b interface when using the op- Use the "ipp" command to view and configure IPP settings. tional IEEE 802.11b interface ❖ Viewing settings unit. You cannot specify the IEEE The following command displays the current IPP settings: 2 1394 interface. msh> ipp Note ❒ To get the above addresses, contact your network administrator. ❒ Use the default configuration if you cannot obtain setting addresses. ❒ The IP address, subnet mask and broadcast address are the same as that for the ethernet interface and IEEE 802.11b interface. ❒ When installing the optional 1394 Interface board, set the IP address and subnet mask so that it does not overlap with the ethernet interface or the IEEE 1394 interface. ❖ IPP timeout configuration Specify how many seconds the computer waits before canceling an interrupted print job. The time can be entered between 30 to 65535 seconds. msh> ipp timeout [30 - 65535] ❖ IPP user authorization configuration Use IPP user authorization to restrict users to print with IPP. The default is "off". msh> ipp auth {basic|digest|off} ❒ TCP/IP configuration is the same for both Ethernet and IEEE 802.11 interface. If interfaces are changed, the new interface inherits the configuration. ❒ Use "0x" as the initial two letters of a hexadecimal address. info Use the "info" command to display printer information such as paper tray, output tray, and printer language. ❖ Printer information display msh> info Reference p.86 "Getting Printer Information over the Network" • User authorization settings are "basic" and "digest". • If user authorization is specified, register a user name. You can register up to 10 users. ❖ IPP user configuration Configure IPP users according to the following messages: msh> ipp user The following message appears: msh> Input user number (1 to 10): Enter the number, user name, and password. msh> IPP user name:user1 msh> IPP password:******* After configuring the settings, the following message appears: User configuration changed. 69