Ricoh MP 2554 User Guide - Page 243
When Other Messages Appear, The wireless LAN
View all Ricoh MP 2554 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
When Other Messages Appear When Other Messages Appear Message Cause Solution "Cannot connect with the wireless card. Turn the main power switch off, then check the card." (A "wireless LAN board" or "Bluetooth interface unit" is referred to as a "wireless card".) • The wireless LAN board was not inserted when the machine was turned on. • The wireless LAN board was pulled out after the machine was turned on. • The settings are not updated although the unit is detected. Turn off the power, and then check the wireless LAN board is inserted correctly. After this, turn on the power again. If the message appears again, contact your service representative. "Cannot connect with the Bluetooth interface. Check the Bluetooth interface." • The Bluetooth interface unit was installed while the machine was turned on. • The Bluetooth interface unit was removed while the machine was turned on. Turn off the power, and then confirm that the Bluetooth interface unit was installed correctly. After this, turn on the power again. If the message appears again, contact your service representative. "Clean the scanning glass. (Located next to the exposure glass.)" The scanning glass or guide plate of the ADF is dirty. Clean the scanning glass or guide plate. See "Maintaining Your Machine", Maintenance and Specifications. "Following output tray is full. The output tray is full. Remove paper." Remove paper from the output tray to resume printing. If paper is delivered to the finisher shift tray and you want to prevent paper from falling off the tray, press the [Stop] key to suspend printing, and then remove the paper. Press [Continue] on the display panel to resume printing. 241