Ricoh SP 330DN Setup Guide - Page 11

Easy Setup Using the WPS Button ●● Make sure the Ethernet cable is not connected to the machine. ●● In Steps 9 to 11, configure each setting within two minutes. 10. Press the WPS button on the router (access point) within two minutes. WPS The following item is necessary to set up a Wireless (Wi-Fi) connection. ●● Router (access point) 1. Check that the router (access point) is working correctly. 2. Make sure the wireless LAN option is attached to the machine and the wireless (Wi-Fi) connection is enabled. For details, see page 6 "Attaching the wireless LAN option". 3. Press the [Menu] key. DYG052 4. Press the [ ] or [ ] key to select [Network Settings], and then press the [OK] key. 5. If you are requested to enter a password, press the [Menu] key to enter the character-selection mode, and select a character of the password using the or [ ] key, and press the [OK] Key. When you finish entering the password, press the [OK] key. A password for accessing the [Network Settings] menu can be specified in [Admin. Tools Lock] under [Admin. Tools] menu. 6. Press the [ ] or [ ] key to select [Wireless(Wi-Fi)], and then press the [OK] key. Network Settings 2 4 Wired (Ethernet) Wireless (Wi-Fi) IPv4 Configuration DYG205 7. Press the [ ] or [ ] key to select [WPS], and then press the [OK] key. Wireless (Wi-Fi) Current Connection Input SSID WPS 6 10 DYG206 8. Press the [ ] or [ ] key to select [PBC], and then press the [OK] key. WPS Type 12 PBC PIN DSG092 9. Press the [ ] or [ ] key to select [Yes], and then press the [OK] key. PBC WPS PBC Connect ? Yes No DYG055 "Please push the [AP] within 2 minutes" appears, and the machine starts to connect in PBC method. CHV607 •• For details about how to use the WPS button, refer to the manuals for the router (access point). 11. Check the result. Connection has succeeded: PBC Connection to AP has Succeeded EXIT DYG056 •• Press the [OK] key to return to the screen displayed in Step 8, and then press the [Menu] key to return to the initial screen. Connection has failed: PBC Connection to AP has Failed EXIT DYG057 •• Press the [OK] key to return to the screen displayed in Step 8. Check the configuration for the router (access point), then try the connection again. 12. Configuring the Wireless (Wi-Fi) settings is complete. 13 To use the printer driver, install the printer driver according to the procedure on page 11 "Easy Setup Using the CD-ROM" and select "The machine's IP address has been already configured." on step 6. Easy Setup Using a PIN Code ●● Make sure the Ethernet cable is not connected to the machine. ●● In Steps 12 to 14, configure each setting within two minutes. ●● To establish a connection using the PIN code, use a computer that is connected to the router (access point). ●● The following item is necessary to set up a Wireless (Wi-Fi) connection. ●● Router (access point) 1. Check that the router (access point) is working correctly. 2. Open the PIN code configuration window (web page) for the router (access point) on your computer. 3. Make sure the wireless LAN option is attached to the machine and the wireless (Wi-Fi) connection is enabled. For details, see page 6 "Attaching the wireless LAN option". 9