Ridgid RV2600B Owners Manual - Page 16
Maintenance cont.
View all Ridgid RV2600B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
SP6636 1/10/07 9:52 AM Page 16 Maintenance (cont.) 1. Remove filter from vac. Gently tap filter against the inside wall of your dust drum. The debris will loosen and fall. 2. For thorough cleaning of dry filter with fine dust (no debris), run water through it as described under "Wet Filter". Wet Filter After filter is removed, run water through the filter from a hose or spigot. Take care that water pressure from the hose is not strong enough to damage filter. Remember: To dry a filter quickly, reinstall the filter on the vac and allow the unit to run for approximately 10 minutes. The clean air rushing through the filter will dry it. IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears in it. Even a small hole can cause a lot of dust to come out of your vac. IMPORTANT: If Damaged, Replace Filter Immediately. Installation Refer to "Replacement Filter Assembly" Section of this manual. Allow the filter to dry before reinstalling and storing the vac. Cleaning and Disinfecting the Wet/Dry Vac To keep your Wet/Dry Vac looking its best, clean the outside with a cloth dampened with warm water and mild soap. To clean the drum: 1. Dump debris out. 2. Wash drum thoroughly with warm water and mild soap. 3. Wipe out with dry cloth. Before prolonged storage or as needed (i.e., waste water pick up) the drum should be disinfected. To disinfect the drum: 1. Pour 1 gallon of water and 1 teaspoon chlorine bleach into the drum. 2. Let solution stand for 20 minutes, carefully swishing every few minutes, making sure to wet all inside surfaces of the drum. 3. Empty drum after 20 minutes. Rinse with water until bleach smell is gone. Allow drum to dry completely before sealing the motor on the drum. Storage Before storing your vac, the drum should be emptied and cleaned. The cord should be wrapped around the unit and the hose should be stored as described in this manual. Accessories should be kept in the same area as the vac so they can be readily available. The vac should be stored indoors. Casters and Wheels Should your cart squeak or become hard to roll, you should place two or three drops of general purpose oil on each wheel at the axle. If your casters are noisy, you may put a drop of oil on the roller shaft to make them quieter. Frame and Handles Your metal handle is painted to prevent rust, however, liquids and corrosive debris should be wiped off with a soft cloth should they come in contact with the handle. WARNING: To assure product SAFETY and RELIABILITY, repairs and adjustments should be performed by Authorized Service Centers, always using RIDGID replacement parts. 16