Ridgid WD0671 Owners Manual - Page 5
Caster/Caster Foot Assembly, Filter Removal and Installation
View all Ridgid WD0671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
SP6737-1 Ridgid 7/26/10 3:33 PM Page 5 Caster/Caster Foot Assembly 1. Turn the dust drum upside down on the floor. 2. Insert the caster feet into the bottom of drum, as shown (4 places). 3. Push on the caster foot until the foot is flush with bottom of the dust drum. 4. Insert the caster stem into the socket of the caster foot, as shown (4 places). 5. Push on the caster until the ball on the caster stem is inserted all the way into the socket. You will hear the ball snap into the socket and the caster will swivel easily when positioning is correct. 6. Turn the drum upright. Caster Foot Dust Drum Hole Caster Caster Stem Caster Ball Pin Filter Removal and Installation Removal and Installation of the Qwik Lock™ Filter Filter Removal: 1. Hold the filter tabs of the Qwik Lock™ filter in each hand. 2. With one thumb on the Qwik Lock™ stud, which protrudes through the integrated filter plate, lift up on the filter tabs while pushing down on the stud. 3. This action will cause the filter to release from the filter cage. Slide filter off cage. Filter Installation: 1. Carefully slide the Qwik Lock™ filter over the filter cage and press down on the outside edge of the filter until the rubber gasket on the bottom of the filter seats securely around the base of the filter cage and against the lid. 2. Align the small center hole in the top of the filter over the Qwik Lock™ stud on the filter cage. Press firmly on top of the filter near the stud to allow the filter to snap over the ball on the end of the stud. The filter is now attached. Integrated Filter Plate with Center Hole PUSH DOWN Filter Tabs (2) Filter Cage PULL UP Rubber Gasket at Bottom of Filter (cutaway view) Qwik Lock™ Stud Lid NOTE: Failure to properly seat the bottom gasket could result in debris bypassing the filter. 5