Rocketfish RF-TVMLPT03V3 User Guide - Page 12
Option 2: Installing on a solid concrete or concrete, block wall
View all Rocketfish RF-TVMLPT03V3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
STEP 5 - Option 2: Installing on a solid concrete or concrete block wall CAUTION: To prevent property damage or personal injury, never drill into mortar between blocks. Mount wall plate directly onto the concrete surface. 1 Align the wall plate template (D) at the height you determined in the previous step and make sure that it is level. Tape the wall plate template to the wall, then use a pencil to mark the lag bolt hole locations (4). Remove the wall plate template. 2 Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit. 3 Insert the concrete wall anchors* into the pilot holes and use a hammer to make sure the anchors are flush with the concrete surface. 4 Align the wall plate (A) with the anchors, insert the lag bolts (T) through the lag washers (S) and the holes in the wall plate, then tighten the lag bolts only until they are firm against the wall plate. CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (T). *Not included. Call Customer Service to have the Fischer UX10 x 60R concrete anchor kit shipped directly to you. 12 Need help? Call 1-800-620-2790 (U.S. and Canada)