Rocketfish RF-WHD210 Quick Setup Guide (English) - Page 1

RF-WHD210 I 4-port Wireless HD Kit Quick Setup Guide Package contents Introduction Thank you for purchasing the Rocketfish 4-port WirelessHD Kit. This product is designed to wirelessly send fully uncompressed signals from up to four HDMI source devices, such as a Blu-ray player, cable/satellite set-top box, gaming console, laptop, etc., to a HDTV or projector at a distance of up to 30 feet within the same room. It is important to note that the 60 GHz frequency with which this product transmits provides the necessary bandwidth to send every bit of information from the source device to the display with no compression or bit dropping, but does not penetrate wall or floors. Therefore, this product is not designed to send signals from one room to another. Please follow the steps in this Quick Setup Guide to ensure a successful installation of this product. If you experience any difficulty setting the product up after referring to this guide, please consult the more detailed User Guide, also included in the package, which contains some troubleshooting techniques that may help. If the additional instructions and troubleshooting section of the User Guide prove unsuccessful for your setup, please contact our customer service department at 800-620-2790 or visit www.rocketfishproducts.com for additional assistance. 60 GHz WirelessHD transmitter Wall mounting bracket (for use with the receiver) 60 GHz WirelessHD receiver AC power adapter for receiver Remote control AC power adapter for transmitter High-speed HDMI cables (2) Setting up the WirelessHD Kit Tips: • The WirelessHD transmitter and receiver are pre-paired at the factory, and should discover each other within about one minute after being set up and powered on as described in these instructions. • Test the placement of the transmitter and receiver for a good signal prior to permanently mounting or installing everything. • For best performance and range, mount the receiver vertically on the wall next to the TV (not behind the TV), or upside-down on the ceiling next to the projector. Make sure that you can see the Rocketfish and WiHD logos on the receiver from the location in the room where the transmitter is located. For more details about mounting the receiver, see your User Guide. • Use only good quality high-speed HDMI cables for all connections, such as Rocketfish brand cables. Poorly constructed HDMI cables can negatively impact performance and may not support all of the features included in your connected devices. • Do not place the transmitter or receiver inside a cabinet or other location where they will not have a clear view of the room. Top view Transmitter 32.8 ft. (10 m) Transmitter Side view 32.8 ft. (10 m) 16.4 ft. (5 m) 47° Receiver 47° 16.4 ft. (5 m) Floor 82° 82° 16.4 ft. 16.4 ft. (5 m) Receiver (5 m) 1 Connect your HDMI source devices (up to four) to the WirelessHD transmitter with high-speed HDMI cables. HDMI cable(s) 2 Connect the WirelessHD receiver to the TV or projector with a high-speed HDMI cable. HDMI cable OR 3 Connect the included AC adapters for the transmitter and receiver to the DC input jacks, then plug them both into an available AC outlet. Note: The included AC adapters are labeled to ensure the correct adapter is used with the transmitter and receiver. 4 Power on the TV or projector and at least one of the source devices that is connected to the transmitter. Note: Be sure the TV or projector is switched to the HDMI input to which the WirelessHD receiver is connected.