Ryobi CSB142LZK English Manual - Page 16
Using The Laser Guide, Warning
View all Ryobi CSB142LZK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
OPERATION USING THE LASER GUIDE See Figure 14. WARNING: Do not stare into the laser beam or turn the laser on when the tool is not in use. Failure to heed this warning could result in possible serious personal injury. The laser guide will generate a red laser beam on the work surface in front of the saw when turned on. The laser aids in following the line of cut when cutting the workpiece. NOTE: The laser unit comes from the factory already installed and aligned. If the laser becomes misaligned after time, refer to the Adjustments section later in this manual. Unplug the saw. Mark the line to be cut on the workpiece. Adjust the depth and angle of the cut as needed. Plug the tool into a power supply and press the laser guide button to activate the laser. Start the motor. NOTE: Do not touch the blade to the workpiece until the saw has reached maximum speed. Slowly push the saw forward into the workpiece. NOTE: Keep the laser beam on the marked line on the workpiece for precision cutting. Once the cut is complete, allow the saw to come to a complete stop before turning off the laser. LED WORKLIGHT See Figure 15. Depress the LED worklight button to turn the LED light ON or off. Always turn the light off when the saw is not in use. laser guide BUTTON laser BEAM LED WORKLIGHT BUTTON push in TO TURN ON push in TO TURN OFF 51.5 30 15 Fig. 14 push in TO TURN ON push in TO TURN OFF 45 45 51.5 30 15 lED WORKLIGHT Fig. 15 16