Ryobi P2060 User Manual - Page 12

MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts could create a hazard or cause product damage. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. WARNING: To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance. GENERAL MAINTENANCE Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please call 1-800-860-4050 or contact an authorized service center for assistance. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING: Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which could result in serious personal injury. Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at an Authorized Service Center. SPOOL REPLACEMENT See Figure 17. Use only 0.065 in. diameter round, 0.065 in. twisted, or 0.080 in. twisted monofilament line. Use original manufacturer's replacement line for best performance.  Remove the battery pack.  Push in tabs on side of spool retainer.  Pull spool retainer up to remove.  Remove the old spool.  To install the new spool, make sure the line is captured in the slot on the new spool. Make sure the end of the line is extended approximately 6 in. beyond the slot.  Install the new spool so that the line and slot align with the eyelet in the string head. Thread the line into the eyelet.  Pull the line extending from the string head so the line releases from the slot in the spool.  Reinstall the spool retainer by depressing tabs into slots and pushing down until spool retainer clicks into place. LINE REPLACEMENT See Figures 17 - 18.  Remove the battery pack.  Remove the spool from the string head. NOTE: Remove any old line remaining on the spool.  Cut a piece of line approximately 9 ft. long. Use only 0.065 in. diameter round, 0.065 in. twisted, or 0.080 in. twisted monofilament line.  Insert the line into the anchor hole in the upper part of the spool. Wind the line around the upper part of the spool clockwise, as shown by the arrows on the spool. Place line in the slot on upper spool flange, leaving about 6 in. extended beyond the slot. Do not overfill. After winding the line, there should be at least 1/4 in. between the wound line and the outside edge of the spool.  Replace the plastic retainer, spool, and the spool retainer. Refer to Spool Replacement earlier in this manual. 10 - English