Ryobi P212 English Manual - Page 16
Bit Storage, Mag Tray™, Magnetic Bit Holder, Installing/removing The Magnetic Bit, Holder
View all Ryobi P212 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
OPERATION BIT STORAGE See Figure 11. When not in use, bits provided with the drill can be placed in the storage areas located on the base of the drill. MAG TRAY™ See Figure 12. The magnetic tray conveniently stores screws or other small parts. MAGNETIC BIT HOLDER See Figure 12. The magnetic bit holder extends the reach of the bit and holds the bit and screws until you are ready to drive them. Storage for the bit holder is located on the front of the tool's base. INSTALLING/REMOVING THE MAGNETIC BIT HOLDER See Figure 13. Lock the switch trigger by placing the direction of rotation selector in the center position. Open or close the chuck jaws to a point where the opening is slightly larger than the end of the magnetic bit holder. Also, raise the front of the drill slightly to keep the bit holder from falling out of the chuck jaws. Insert the bit holder. NOTE: Open the chuck jaws just enough to fully insert the end of the magnetic bit holder. The body of the bit holder should rest against the chuck jaws when the jaws are closed and tightened. Tighten the chuck jaws on the bit holder. Insert a bit into the open end of the magnetic bit holder. Tighten the chuck jaws on the bit holder. To remove the magnetic bit holder, see Removing Bits. BIT(S) SCREWS BIT CHUCK JAWS BIT STORAGE Fig. 11 BIT HOLDER STORAGE MAG TRAY Fig. 12 UNLOCK (RELEASE) MAGNETIC BIT HOLDER 16 LOCK (TIGHTEN) CHUCK BODY Fig. 13