Ryobi P300 English Manual - Page 9

OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this tool for the following purposes:  Light-duty stapling or nailing into wood This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. For complete charging instructions, refer to the Operator's Manual for the battery packs and chargers listed in the General Safety Rules. TO INSTALL BATTERY PACK See Figure 2.  Place battery pack in the tool. Align raised rib on battery pack with groove inside tool.  Make sure the latches on each side of the battery pack snap in place and battery pack is secured in tool before beginning operation. TO REMOVE BATTERY PACK See Figure 2.  Locate latches on side of battery pack and depress to release battery pack from the tool.  Remove battery pack from the tool. LOADING THE TOOL WITH STAPLES See Figures 3 and 4.  Remove battery pack from the tool.  Hold tool upside down; squeeze latch and slide base open.  Place staples in channel, legs facing upward and close base.  Make sure the latch is securely locked in place.  Reattach battery pack to tool.  LATCH STAPLES BATTERy PACK LATCHES DEPRESS LATCHES TO RELEASE BATTERY PACK Fig. 2 Fig. 3 Fig. 4