Ryobi P301 Operation Manual - Page 11

OPERATION NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to CHARGING A COOL BATTERY PACK for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check. TO INSTALL BATTERY PACK See Figure 3. � Place battery pack in your tool. Align raised rib on battery pack with groove inside tool. � Make sure the latches on each side of the battery pack snap in place and battery pack is secured in tool before beginning operation. CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installation of the battery pack can cause damage to internal components. TO REMOVE BATTERY PACK See Figure 3.  Locate latches on side of battery pack and depress to release battery pack from the tool.  Remove battery pack from the tool. WARNING: Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side. LOADING THE TOOL WITH STAPLES See Figures 4 - 5.  Remove battery pack from the tool.  Hold tool upside down; squeeze latch and slide base open.  Place staples in channel, legs facing upward and close base.  Make sure the latch is securely locked in place.  Reattach battery pack to tool. LATCH STAPLES BATTERY PACK LATCHES DEPRESS LATCHES TO RELEASE BATTERY PACK Fig. 3 Fig. 4 Fig. 5 11