Ryobi P320 Operation Manual - Page 12
Troubleshooting
View all Ryobi P320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
troubleshooting PROBLEM POSSIBLE CAUSE Work-contacting element does not Low nails depress fully - tool does not operate. Work-contacting element is jammed Tool operates properly, but fasteners do Air pressure is too low not drive fully Depth of drive isn't deep enought Nail is too long for wood hardness Tool operates properly, but fasteners are Air pressure is too high driven too deep Depth of drive is too deep SOLUTION Replenish nails Remove battery and clear debris Increase air pressure Adjust depth of drive Use nail length that is appropriate for wood Decrease air pressure Adjust depth of drive Tool jams frequently Tool stops and LED's flash rapidly Incorrect nails Damaged nails Loose magazine Dirty magazine Battery is low or has no charge. Tool is hot Verify that nails are the correct size Replace nails Tighten screws Clean magazine Recharge battery Allow tool to cool Tool has charged battery and LED's Tool has malfunctioned are slowly flashing or LED's do not turn off after approximately ten seconds of non-use. Take tool to nearest authorized repair center NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 14 AFTER FRENCH AND SPANISH LANGUAGE SECTIONS. This product has a Three-year Limited Warranty. For Warranty details go to www.ryobitools.com 12 - English