Ryobi P430 English Manual - Page 12
Application Of Liquid Polish, Apply Polish To Surface, Application Of Paste Polish
View all Ryobi P430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION APPLICATION OF PASTE POLISH See Figure 6. Use a putty knife or other flat, blunt object to apply approximately one rounded teaspoon of paste onto the bonnet. Evenly spread the paste over the entire surface of the bonnet. Do not apply paste directly to the surface being polished. WARNING: Keep a firm grip on the tool with both hands at all times. Failure to do so could result in loss of control leading to possible serious injury. APPLICATION OF LIQUID POLISH See Figure 7. Apply a small circle of liquid (about the size of a half-dollar) around the center of the bonnet, followed by two more rings, each slightly larger than the previous one. After the first application, the bonnet will not absorb as much polish. Apply two rings of polish to the bonnet for subsequent applications, using half of the initial quantity. APPLY POLISH TO SURFACE See Figure 8. While holding the buffer/polisher firmly against the surface, slide the ON/OFF switch to the ON position (to the left). Always start and stop the polisher on or against the surface being polished. Begin by polishing larger flat surfaces, such as the hood, trunk and roof. Use a broad sweeping motion in a crisscross pattern. Do not press down on the surface with the polisher. Let the orbital action of the pad and bonnet do the work. Once flat surfaces have been covered, polish curved surfaces such as car doors and quarter panels. Use small circular motions. After applying polish to the entire surface, turn buffer/polisher off. Wait until the pad stops rotating before lifting the buffer/polisher from the surface. For hard to reach areas, such as the underside of bumpers or side mirrors, apply polish by hand. 12 WAX Fig. 6 Fig. 7 Fig. 8