Ryobi P4500K Operator Manual - Page 7

OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always remove battery pack from the tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purpose listed below: „ The power scrubber can be used to clean exterior and interior surfaces. „ This product is not for commercial use. INSTALLING/REMOVING BATTERY PACK See Figure 2, page 10. NOTE: This product is not recommended for use with RYOBI ONE+ battery packs larger than 4.0Ah. If installed, large capacity battery packs will prevent the battery cover from closing completely exposing the battery and the battery port to moisture, debris, and other contaminants. „ Unlock the tab and open the battery cover. „ Insert the battery pack into the product as shown. „ Make sure the latches on each side of the battery pack snap into place and the battery pack is secured before beginning operation. „ Close the battery cover and lock the tab. „ To remove, open the cover and depress the latches on both sides of the battery pack. For complete charging instructions, see the operator's manuals for your battery pack and charger. WARNING: Do not operate the scrubber with the battery door open. An open door could expose the battery and battery compartment to wet conditions which could increase the risk of electric shock. SELECTING A BRUSH ACCESSORY Selecting the correct type of brush accessory is important in order to obtain the best performance from the power scrubber. Select the brush accessory based on the application and on the surface you wish to clean. Selecting the right brush accessory will help you clean more efficiently and protect the surface being cleaned. To reduce the risk of property damage, always test the brush in an inconspicuous area of a surface before beginning a project. NOTE: A brush accessory with medium bristles is included with your power scrubber. Brush accessories with hard and soft bristles can be purchased where you bought this product. BRUSH ACCESSORY SELECTION GUIDE Soft Bristle (Blue) Light Duty Cleaning Medium Bristle (Green) General Purpose Cleaning Hard Bristle (Gray) Heavy Duty Cleaning INSTALLING/REMOVING BRUSH ACCESSORIES See Figure 3, page 10. „ Remove the battery pack. „ Align the triangular hole in the brush accessory with the triangular stud on the connector. „ Slide the brush accessory onto the connector. „ Hold the connector sleeve and rotate the brush accessory counterclockwise to lock it in place. NOTE: When locked, the triangular hole and triangular stud will be misaligned. 7 - English