Ryobi P516 User Manual - Page 19
To Assemble The Sliding Table, Assembly
View all Ryobi P516 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
ASSEMBLY To adjust (horizontally and vertically): Remove the anti-kickback pawls and blade guard assembly. From the back of the saw, loosen the screws holding the mounting bracket. Reposition the riving knife left or right as needed to align the riving knife with the saw blade. Once properly aligned, securely retighten all screws. Check again for squareness and continue to adjust if needed. TO ASSEMBLE THE SLIDING TABLE ASSEMBLY See Figures 17 - 18. To install sliding table assembly: Locate the sliding table assembly. Unlock the front and back table locking levers. Insert sliding table assembly into table locking levers. Push the table assembly until it rests against the saw table and is completely closed. Install phillips head screw into hole on the bottom of the rear extension rod to hold sliding table assembly into locking levers. Lock the front and back table locking levers. To install indicator: Press the end cap over the front extension rod as shown in figure 18. Locate the indicator. Slip the indicator in the slot on the front rail. Fit the top slot in the indicator over the detent on the end plug and the bottom slot over the screw hole on the end plug. Insert a screw into the bottom slot of the indicator, the hole in the end plug and the extension rod. Tighten securely, but do not overtighten. Overtighting may crush extension rod ends. REAR EXTENSION ROD INDICATOR SLIDING TABLE ASSEMBLY Fig. 17 TABLE LOCKING LEVER END CAP SCREW EXTENSION ROD 19 - English DETENT Fig. 18