Ryobi P730 English Manual - Page 13

OPERATION INFLATING WITH THE HIGH PRESSURE AIR HOSE AND ADAPTORS See Figure 10 - 13. The high pressure air hose can be used with the provided adaptors to inflate a variety of items. TO uNlock AIR CHUCK AdaptorS  Insert adaptor into air chuck and push air chuck clamp down until it locks into place.  To remove, lift air chuck clamp up and remove adaptor from air chuck. TO LOck ADAPTORS See Figures 10 - 12. The supplied adaptors perform a variety of functions. The Schrader valve removal tool can be used to remove valve cores for quick deflation. The tapered adaptor can be used on smaller pinch valves to inflate items like floats and children's toys, which usually require the user to inflate them by blowing air into them. The sport ball needle can be used to inflate any type of sports ball or any other item that requires an inflation sport ball needle. Fig. 11 Schrader TAPERED Sport ball pResta VALVE Valve Removal Adaptor needle ADAPTOR Tool To use the sport ball needle:  Insert sport ball needle into sports ball valve and in- flate.  Remove sport ball needle after inflation. NOTE: Pressure required for most sports balls is too low for accurate reading on gauge. The Presta valve adaptor can be used for Presta valve stems as described below. (See Figure 12) Before inflating a tire with a Presta valve, loosen the locking nut on the valve stem to inflate. Once inflation is complete, tighten the locking nut to seal the tire valve. To use the Presta valve adaptor: TO TIGHTEN LOCKING NUT Fig. 12 TO LOOSEN PRESTA VALVE STEM  Loosen Presta valve locking nut.  Thread Presta valve adaptor onto valve stem with larger open end toward wheel. Fig. 13  Position the air chuck clamp in the unlock position.  Clamp the end of the air chuck down onto the Presta valve adaptor by pressing air chuck clamp down until it locks into place.  After inflation, remove air chuck and tighten locking nut. ADAPTOR STORAGE See Figure 14. When not in use, adaptors provided with the inflator can be placed in the removable storage cradle located on the inside cover of the inflator. ADAPTOR TRAY HOSE STORAGE Hose Storage Fig. 14 See Figure14. When not in use, the air hoses provided with the inflator can be placed in the storage areas located on both sides of the inflator. NOTE: Do not store low pressure hose with pinch valve adaptor in place on small inflatable nozzle. 13