Ryobi RTS30 English Manual - Page 19
Assembly, Operation - dust bag
View all Ryobi RTS30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
ASSEMBLY TO INSTALL BLADE GUARD ASSEMBLY See Figure 14. Proper installation of the blade guard assembly means that the saw blade and spreader are in alignment. ALWAYS align the spreader to the saw blade prior to turning on the table saw. Lower the blade. Install the blade guard assembly to the mounting plate using the wing nut. Partially retighten the wing nut. Check the blade and spreader alignment. NOTE: Blade alignment with the spreader can be adjusted for different blade widths. Refer to: To Check, and Align the Spreader, Saw Blade, and Blade Guard Assembly in the Adjustment section. Check the blade guard assembly for clearances and free movement. Tighten wing nut securely. TO INSTALL dust bag See Figure 15. Slide the elbow inside the dust chute on the back of the table saw. Slide the dust bag into the elbow. NOTE: For efficient operation, empty the dust bag before it is half full. This will permit better air flow through the bag. anti-kickback pawls spreader WING NUT MOUNTING PLATE Fig. 14 DUST CHUTE ELBOW DUST BAG OPERATION Fig. 15 WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes causing possible serious injury. 19