Ryobi RTS30 English Manual - Page 27

To Use Outfeed Support, To Use The Table Extension

Get Ryobi RTS30 PDF manuals and user guides View all Ryobi RTS30 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

operation to use OUTFEED SUPPORT See Figure 30. The outfeed support slides to give the operator additional support for cutting long workpieces.  With the table saw in the off position, stand behind the saw.  Grasp the outfeed support with both hands and pull it until it is fully extended. to use the table extension See Figure 31. The table extension provides the operator with additional table width for supporting wider workpieces. To extend:  Push the table extension lever beneath the saw table towards the back of the saw.  Grasp the table extension with both hands and pull it until the scale on the front rail indicates the desired measurement.  Retighten the table extension lever by pulling it towards the front of the saw. To close:  Push the table extension lever beneath the saw table towards the back of the saw.  Push the table extension with both hands back toward the saw table.  Retighten the table extension lever by pulling it towards the front of the saw. OUTFEED SUPPORT Fig. 30 TABLE EXTENSION LEVER LOWER SCALE Fig. 31 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
27
OPERATION
TO USE OUTFEED SUPPORT
See Figure 30.
The outfeed support slides to give the operator additional
support for cutting long workpieces.
With the table saw in the
OFF
position, stand behind the
saw.
Grasp the outfeed support with both hands and pull it
until it is fully extended.
TO USE THE TABLE EXTENSION
See Figure 31.
The table extension provides the operator with additional
table width for supporting wider workpieces.
To extend:
Push the table extension lever beneath the saw table
towards the back of the saw.
Grasp the table extension with both hands and pull
it until the scale on the front rail indicates the desired
measurement.
Retighten the table extension lever by pulling it towards
the front of the saw.
To close:
Push the table extension lever beneath the saw table
towards the back of the saw.
Push the table extension with both hands back toward
the saw table.
Retighten the table extension lever by pulling it towards
the front of the saw.
Fig. 30
OUTFEED
SUPPORT
Fig. 31
LOWER
SCALE
TABLE
EXTENSION
LEVER