Ryobi RTS31 User Manual - Page 15
To Attach The Leg, To Secure/level The Saw, To Install The Handle
View all Ryobi RTS31 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ASSEMBLY to attach the Leg See Figure 7. NOTE: The leg with the leveling foot should be installed on the front of the saw, right side. n Stand the table saw on end as shown in figure 7. n Slide the leg in the leg stand tubes aligning the holes in both tubes. n Remove the nut from the end of the carriage bolt then insert a carriage bolt into the hole (from the outside toward the inside). Finger tighten using the nut. n Repeat for remaining legs. NOTE: Once the leg stand is in an upright position (see page 16) and the saw is level, securely tighten the nuts. Place the saw on level ground and verify the saw's stability before use. to secure/level the saw With the leg stand open and the table saw resting on a flat, level surface, the saw should not move or rock from side to side. If the saw rocks from side to side, the leveling foot needs adjusting until the leg stand is balanced. n Turning clockwise will lower the foot. n Turning counterclockwise will raise the foot. to install the Handle See Figure 8. Remove the screw from the handle by holding the nut securely and turn the screw counter- clockwise to remove the nut completely. NOTE: Do not remove the screw from the handle or the washer from the end of the screw. Place the nut into the recessed hole on the back of the height/bevel adjusting handwheel and hold in place. Slide the handle, screw, and washer into the hole on the height/bevel adjusting handwheel. Using a flathead screwdriver, turn the screw clockwise and tighten in place. sleeve NUT carriage bolt FLAT washer spacer FLAT washer bolt wheel Fig. 6 leg stand tube NUT Fig. 7 HEIGHT/bevel ADJUSTING HANDWHEEL SCREW washer HANDLE NUT 15 Fig. 8