Ryobi RY14110 Operator's Manual - Page 17
Make The Most Of Your Purchase - problems
View all Ryobi RY14110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER. PROBLEM Handle not in position POSSIBLE CAUSE Carriage bolts not seated properly. Handle knobs not tightened. SOLUTION Adjust the height of the handle and make sure the carriage bolts are seated properly. Tighten handle knobs. Mower not starting Battery is low in charge. Charge the battery. Battery is either inoperable or will not Replace the battery. take a charge. Mower cutting grass unevenly Mower not mulching properly Mower hard to push Mower not bagging properly Mower vibrating at higher speed Mower doesn't self-propel Motor stops while cutting Lawn is rough or uneven or cutting Move the wheels to a higher position. height not set properly. All wheels must be placed in the same cutting height for the mower to cut evenly. Wet grass clippings sticking to the un- Wait until the grass dries before mow- derside of the deck. ing. High grass, rear of mower housing and Raise cutting height. blade dragging in heavy grass, or cutting height too low. Cutting height set too low Raise cutting height. Blade is unbalanced, excessively or unevenly worn. Replace the blade. Bent motor shaft. Cutting height set too low Stop the motor, remove fuse key and battery, disconnect the power source, and inspect for damage. Have repaired by an authorized service center before restarting. Take the mower to an authorized service center. Raise the cutting height MAKE THE MOST OF YOUR PURCHASE! Go to http://register.ryobitools.com and register your new tool on-line. Your product has been fully tested prior to shipment to ensure your complete satisfaction. For any questions about operating or maintaining your product, call the Ryobi Help Line! 13 - English