Ryobi RY40225 User Manual - Page 12
Assembly, Operation
View all Ryobi RY40225 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ASSEMBLY TO ATTACH THE STRAIGHT SHAFT GRASS DEFLECTOR - S430 See Figure 6. Remove the wing screw from the grass deflector. Insert the tab on the mounting bracket in the slot on the grass deflector. Align the screw hole in the mounting bracket with the screw hole in the grass deflector. Insert the wing screw through the mounting bracket and into the grass deflector. Tighten the screw securely. OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. FUELING AND REFUELING THE TRIMMER WARNING: Gasoline and its vapors are highly flammable and explosive. To prevent serious personal injury and property damage, handle it with care. Keep away from ignition sources and open flames, handle outdoors only, do not smoke and wipe up spills immediately. Clean surface around fuel cap to prevent contamination. Loosen fuel cap slowly by turning counterclockwise. Rest the cap on a clean surface. Carefully pour fuel into the tank. Avoid spillage. Prior to replacing the fuel cap, clean and inspect the gasket. Immediately replace fuel cap and hand tighten by turning it clockwise. Wipe up any fuel spillage. NOTE: It is normal for smoke to be emitted from a new engine after first use. WARNING: Operation of this equipment could create sparks that can start fires around dry vegetation. A spark arrestor may be required. The operator should contact local fire agencies for laws or regulations relating to fire prevention requirements. WARNING: Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. from refueling site before starting engine. Do not smoke and stay away from open flames and sparks. Failure to safely handle fuel could result in serious personal injury. OXYGENATED FUELS NOTICE: Do not use E15 or E85 fuel (or fuel containing greater than 10% ethanol) in this product. It is a violation of federal law and will damage the unit and void your warranty. Fuel system damage or performance problems resulting from the use of an oxygenated fuel containing more than the percentage of oxygenates stated below are not covered under warranty. Ethanol. Gasoline containing up to 10% ethanol by volume (commonly referred to as E10) is acceptable. E15 and E85 are not. ADDING/CHECKING ENGINE LUBRICANT See Figure 7. NOTICE: Attempting to start the engine before it has been properly filled with lubricant will result in equipment failure. Engine lubricant has a major influence on engine performance and service life. This unit is shipped with Ryobi 4-cycle 20W50 engine lubricant. For best operating performance, continued use of this lubricant is recommended. NOTE: Always use a 4-stroke engine lubricant that meets or exceeds the requirements for API service classification SJ. SAE 30, 10W30, or 10W40 are all acceptable lubricants to use in this product. Non-detergent or 2-stroke engine lubricants will damage the engine and should not be used. 8 - English