Ryobi RY803325 Operation Manual - Page 21

TROUBLESHOOTING PROBLEM Engine fails to start POSSIBLE CAUSE SOLUTION No fuel in tank Fill tank Water pressure in hose Squeeze trigger to relieve water pressure Spark plug shorted or fouled Replace spark plug Spark plug is broken (cracked porcelain or Replace spark plug electrodes broken) Ignition lead wire shorted, broken, or disconnected Replace lead wire or attach to spark plug from spark plug Ignition inoperative Contact a qualfied service center Engine hard to start Water in gasoline Weak spark at spark plug Drain entire system and refill with fresh fuel Contact a qualfied service center Engine lacks power Dirty air filter Clean or replace air filter Air in line causing idle down feature to perform With engine off, squeeze trigger until water comes incorrectly out to remove air from line. Detergent fails to mix Spray selector on the 5-in-1 Change-over Nozzle Rotate the spray selector on the 5-in-1 Change- with spray is set to either the 40º, 25º, or 15º setting over Nozzle to either the short range detergent [ ] or long range detergent [ ] setting. Soap tank is empty Add detergent to soap tank Pump doesn't produce Spray selector on the 5-in-1 Change-over Nozzle Rotate the spray selector on the 5-in-1 Change- pressure is set to either the short range detergent [ ] or over Nozzle to either the 40º, 25º, or 15º setting long range detergent [ ] setting. Inadequate water supply Provide adequate water flow Trigger handle or spray wand leaks Check connections and / or replace trigger handle or spray wand Nozzle is clogged Clean nozzle Air in line Squeeze trigger on trigger handle to remove air from line Hose is leaking Replace hose Kink in hose Eliminate kinks in hose Pump is faulty Contact a qualfied service center Machine doesn't reach Diameter of garden hose is too small high pressure Water supply is restricted Replace with 3/4 in. garden hose Check garden hose for kinks, leaks, and blockages Not enough inlet water Open water source full force Spray selector on the 5-in-1 Change-over Nozzle Rotate the spray selector on the 5-in-1 Changeis set to either the short range detergent [ ] or over Nozzle to either the 40º, 25º, or 15º setting long range detergent [ ] setting If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance. NOTICE: As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance section. It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to perform the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible engine damage and/or void your warranty. This product has a Three-year Limited Warranty for personal, family, or household use (90 days for business or commercial use). For warranty details, visit www.ryobitools.com or call (toll free) 1-800-525-2579. 17 - English