Ryobi SDS60K English Manual - Page 10
Operation
View all Ryobi SDS60K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
OPERATION WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. faster variable speed dial WARNING: Always wear safety goggles or safety glasses with side shields when operating power tools. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury. slower switch trigger Fig. 2 WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. reverse rotation selector forward APPLICATIONS You may use this product for the purposes listed below: Hammer drilling in concrete, brick, or other masonry Drilling in wood Drilling in ceramics, plastics, fiberglass, and laminates Drilling in metals Mixing paint Chiselling ceramics, concrete, brick, or other masonry Fig. 3 SWITCH TRIGGER See Figures 2 - 3. To turn the rotary hammer ON, depress the switch trigger. To turn it OFF, release the switch trigger. sds bit VARIABLE SPEED DIAL See Figures 2 - 3. sds chuck The variable speed dial on the switch trigger delivers higher speed by turning the variable speed dial clockwise. For slower speeds, turn the dial counterclockwise. Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function. DIRECTION OF ROTATION SELECTOR Fig. 4 CAUTION: To prevent gear damage, always allow the chuck to come to a complete stop before changing the direction of rotation. (FORWARD/REVERSE) See Figure 3. To stop the rotary hammer, release the switch trigger and allow the chuck to come to a complete stop. The direction of bit rotation is reversible and is controlled by a selector located above the switch trigger. With the rotary hammer held in normal operating position, the direction of rotation selector should be positioned to the left of the switch trigger for forward drilling. The drilling direction is reversed when the selector is to the right of the switch trigger. NOTE: The rotary hammer will not run unless the direction of rotation selector is pushed fully to the left or right. Avoid running the rotary hammer at low speeds for extended periods of time. Running at low speeds under constant usage may cause the rotary hammer to become overheated. If this occurs, cool the rotary hammer by running it without a load and at full speed. 10