Ryobi WS730 Trilingual - Page 10

FEATURES PUMPLESS FLOW SYSTEM™ - The pumpless flow system sprays clean, fresh water on blade for trouble-free cutting. This fully enclosed water system keeps internal cords and hoses dry and securely out of the way. RIP GUIDE - Rip guide is fully adjustable for straight and miter cuts. SPLASH GUARD - The splash guard provides protection from overspray and mist. UPPER WHEEL GUARD - Protects user from wheel contact on upper portion of wheel. ASSEMBLY UNPACKING This product requires assembly.  Carefully lift the saw from the carton and place on a level work surface.  Inspect the tool carefully to make sure no breakage or damage occurred during shipping.  Do not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.  The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has influenced the settings, refer to specific procedures explained in this manual.  If any parts are damaged or missing, please call 1-800-525-2579 for assistance. Warning: If any parts are damaged or missing do not operate this tool until the parts are replaced. Failure to heed this warning could result in serious personal injury. warning: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury. Installing motor head ASSEMBLY to frame See Figure 6, page 19.  Align the holes in the motor head assembly with the holes on the side of the water tray frame.  Insert large and small socket head screws and finger tighten.  Using the hex key, securely tighten the large socket head screws on the side of the water tray frame.  Tighten the small socket head screws last. Installing eND-of-cUT rEMINDER See Figure 7, page 19. The end-of-cut reminder has two purposes: 1) to keep the garden hose secure and out of the way, and, 2) to slow down the Easy Glide Table™ to help prevent tile from cracking and chipping.  Align the hole in the end-of-cut reminder with the hole in the inside of the back of the water tray frame.  Using a screw, secure the end-of-cut reminder in place. Installing spLASH GUARD See Figure 8, page 20.  Align the hole in the splash guard with the hole in the back of the motor head assembly.  Using the flat washer and screw, secure the splash guard in place. Installing WATER supply VALVE to THE water tray See Figure 9, page 20.  Unscrew the water supply valve cap.  Place the water supply valve into the hole in the water tray as shown in figure 9.  Screw the water supply valve cap onto the threaded end of the valve and tighten securely. Installing Tile Saw to THE water tray See Figure 9, page 20.  Carefully place the water tray frame inside the water tray. Saw head assembly goes to the back of the frame where the hose connections are located. 10 - English