Ryobi WS730 Trilingual - Page 16
Note: S Illustrations Start On After, French And Spanish Language S. - pump
View all Ryobi WS730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
MAINTENANCE Brush REPLACEMENT See Figure 29, page 23. The saw has externally accessible brush assemblies that should be periodically checked for wear. Proceed as follows when replacement is required: Unplug the saw. WARNING: Failure to unplug the saw could result in accidental starting causing serious injury. Remove brush cap with a screwdriver. Brush assembly is spring loaded and will pop out when you remove brush cap. Remove brush assembly. Check for wear. Replace both brushes when either has less than 1/4 in. length of carbon remaining. Do not replace one side without replacing the other. Reassemble using new brush assemblies. Make sure curvature of brush matches curvature of motor and that brush moves freely in brush tube. Make sure brush cap is oriented correctly (straight) and replace. Tighten brush cap securely. Do not overtighten. accessories The following recommended accessories are currently available at retail stores: 080009002119 Water Pump A18WS07 Stand WARNING: Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury. NOTE: Figures (illustrations) start on page 17 after French and Spanish language sections. 16 - English