Samsung 910MP User Manual (ENGLISH) - Page 37
Check Signal Cable message - lcd
UPC - 729507708232
View all Samsung 910MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
The following table lists possible problems and their solutions. Before calling for service, check the information in this section to see if you can remedy any problems yourself. If you do need assistance, please call the phone number on the Information section or contact your dealer. Installation | Screen | Audio | Remote Control 1. Problems related to Installation Problems related to the monitor installation and their solutions are listed. Problems Solutions PC It appears the PC does not function normally. z Check if the Display Adapter Driver (VGA Driver) is properly installed. (Refer to Installing Driver) The monitor screen flickers. z Check if the signal cable between the computer and the monitor is securely connected and tightened. (Refer to Connecting to a Computer) TV TV screen is blurred or shows noise signals. z Check if the TV antenna connector is securely connected to the external antenna. (Refer to Connecting to TV) TV signal is not received z Check "Channel system" and make sure you choose the correct channel system. (Refer to the Channel System) z Select "Auto Store" to configure the channel system automatically. (Refer to the Auto Store) 2. Problems related to Screen Problems related to the monitor screen and their solutions are listed. Problems Screen is blank and power indicator is off "Check Signal Cable" message "Not Optimum Mode" message Picture rolls vertically. Image is not clear. Picture is blurred. Picture image is unstable and vibrates. Ghost images are shown in the picture. The image is too light or too dark Solutions z Ensure that the power cord is firmly connected and the LCD monitor is on. (Refer to the Connecting the Monitor) z Ensure that the signal cable is firmly connected to the PC or video sources. (Refer to the Connecting the Monitor) z Ensure that the PC or video sources are turned on. z Check the maximum resolution and the frequency of the video adapter. z Compare these values with the data in the Preset Timing Modes Chart. z Check if the signal cable is securely connected. Connect it again securely. (Refer to Connecting to a Computer) z Run Frequency Coarse and Fine tuning. z Turn on again after removing all accessories (video extension cable, etc.) z Set resolution and frequency to the recommended ranges. z Check if the resolution and frequency set for the computer video card falls in the range supported by the monitor. If not, reset them referring to the current Information under the monitor menu and Preset Timing Modes. z Adjust the Brightness and Contrast. (Refer to the Brightness, Contrast)